Internally Mounted Ventilators – Install Quick Specs
VEN060I
Installation Type & Discharge Direction
Ventilator Motor Ratings*
Hoods without Heat Lamps:
2.8 Amps @ 120 V AC, 60 Hz
Hoods with Heat Lamps:
7.2 Amps @ 120 V AC, 60 Hz
*For maximum power supply required, refer to
hood series selected.
Mounted in hood. Can be mounted for vertical
or horizontal discharge, depending on the
hood specified (see individual hood
specifications)
CFM Rating
640 CFM – Single Blower
1280 CFM – Dual Blower applications
Ventilator Carton Weight:
VEN060I = 23 lbs.
Minimum Duct Size
8” round @ 640 CFM
10” round @ 1280 CFM
Maximum Equivalent Straight Duct Length
50 feet
3
/
9
"
4
Equivalent Straight Lengths
14"
•
•
•
•
•
1 foot of 8” or 10” duct = 1 foot
1 foot of 3 ¼” x 14” rectangular = 1 foot
8” round 90 degree Elbow = 5 feet
10” round 90 degree Elbow = 3 feet
Wall or Roof Cap = 2 feet
1
/
9 "
4
Standard Features
•
•
•
Adaptable to all Wind Crest hoods
Brushed alumized steel construction
Thermally protected, permanently
lubricated motor
VEN060I
U
U
L
L
LISTED7Z66
C
•
Dynamically balanced 5 ½” diameter
blower wheel
When installed in Wind Crest hoods
•
•
•
Neoprene resilient anti-vibration mounted
Low RPM for very quiet performance
Two VEN060I internal blowers can be
mounted in the following hoods. This
requires a dual wire harness (part #10220).
o WSL and WCL hoods 48” or wider
o WER 60” wide hoods
o PSL 66” wide hoods
© 2006 Wind Crest by CNP Industries
1
Install Quick Specs are for planning purposes only. Please refer to the detailed installation
instructions, prior to making any cutouts.
|