Woodstock Saw W1218A User Manual

RotACAtoR  
Adjustment jIG FoR PlAneRs  
Preparation  
1. DISCONNECT PLANER FROM POWER!  
2. Set knives in cutterhead with factory knife-setting jig.  
3. Adjust opening between table and headstock to approximately 4". This gives you  
enough space to work with the Rotacator.  
Small Tip  
Adjusting Planer Bed Parallel to Planer Knives  
1. Insert the large tip into the Rotacator.  
Large Tip  
2. Rotate dial indicator to “Up-Reading” position (see Figure 1).  
3. Place dial indicator between table and cutterhead at one end of the cutterhead.  
4. Gradually reduce opening space until the Rotacator plunger is slightly depressed  
by one of the knives. Make sure that knife is at the lowest point of its cutting arc.  
Figure 1  
5. Note the reading on the dial indicator face.  
6. Remove dial indicator and place it in the same position at the opposite end of the  
knife. Read the dial indicator again. If the readings are not equal on both sides,  
adjust one side of the planer table until readings are the same  
.
Adjusting Bed Rollers  
1. Insert the small tip into the Rotacator.  
Up-Reading Position  
Figure 2  
2. Rotate the dial indicator to the “Down-Reading” position (see Figure 2).  
3. Place the dial indicator on the surface of the planer table.  
4. Loosen the setscrew of the dial indicator, then rotate the face dial until the zero is  
aligned with the pointer. Tighten the setscrew.  
5. Place the dial indicator on the surface of the planer bed so the plunger is touching  
the high point of one end of the bed roller.  
6. Adjust roller height above table to the specifications in the planer owner's manual.  
7. Repeat steps 4 and 5 at the opposite end of the same roller.  
8. Repeat steps 4, 5 and 6 for the other bed roller.  
Down-Reading Position  
Adjusting Power Feed Rollers and Chip Breaker  
1. Insert the small tip into the Rotacator.  
2. Consult your planer instruction manual to determine the proper relationship of the  
infeed and outfeed rollers and chip breaker to the knives or cutterhead. Adjust as  
needed per the instruction manual.  
Copyright © 1994, Woodstock International, Inc. Revised April, 2014 (ST)  
Instructions for Model W1218A  
 

Westinghouse Fan WHO4 User Manual
Westinghouse Flat Panel Television MT80A TILT User Manual
Xantech Universal Remote 48095D User Manual
Xantrex Technology Power Supply RS232 XPD User Manual
X Micro Tech MP3 Player Digital MP3 Player User Manual
Xpelair Fan CF20 User Manual
Yamaha DVD Player 127 User Manual
Yamaha Music Mixer CR 420 User Manual
Zanussi Cooktop ZKF 661 LN User Manual
Zircon Stud Sensor SL AC User Manual