Xantrex Technology Stud Sensor 975 0193 01 01 User Manual

975-0193-01-01  
Revision A  
Battery Temperature Sensor  
Installation Instructions  
Additional Battery Temperature Sensors (Part #: 808-0232-01) can be installed on  
your XC Series or BC Series battery charger. Xantrex recommends that you install  
Battery Temperature Sensors on all banks to protect your batteries and to provide  
optimal charging of each bank. See the label on the outside of the package for  
other Xantrex products compatible with this battery temperature sensor.  
Installing Battery Temperature Sensor  
To install a BTS:  
1. Switch off all devices operating from the battery.  
2. Connect the ring terminal on the sensor directly to the negative battery stud,  
or use the adhesive backing on the sensor back to attach the sensor to any side  
of the battery to be monitored.  
Xantrex recommends you mount the sensor directly on the battery stud as it  
will be more reliable against vibration and will provide a good thermal  
connection to the battery as well.  
3. Route the sensor cable to the charger and plug it into the Bank 1 (default if  
using only one BTS), Bank 2 or Bank 3 connector on the rear panel.  
It may be advantageous to temporarily apply a layer of tape around the  
connector to protect its locking tab from catching on something during pulling  
and routing.  
 

Weider Home Gym 831156071 User Manual
Whirlpool Dehumidifier 1185020 User Manual
Whirlpool Freezer EV090FXK User Manual
Williams Sound Telephone TEL 040 User Manual
Xilinx Network Card UG144 User Manual
Yamaha CD Player CDC 655 User Manual
Yamaha Music Mixer DMP9 16 User Manual
Zanussi Refrigerator ZD 19 4 User Manual
Zanussi Ventilation Hood ZB960 User Manual
Zenoah Brush Cutter BCZ3200DL User Manual